Live ESP32 pin monitor
Green = function active. Buttons and limit switches are active LOW.
* Simulated ADC voltage assumes a calibrated 6:1 divider. GPIO34 reads battery voltage; this is not a specified module ratio.
20 components · 57 connections · one live controller
Drag to rotate · Scroll / pinch to zoom · Right drag / two fingers to pan · Click to inspect
Wiring filters emphasize relevant connections. Click a component or wire to inspect.
Illustrative simulation only. No hardware connection. AUTO MODE arms the schedule; the time buttons trigger RTC events. RESET returns to daytime, lowered, and clears faults.
Green = function active. Buttons and limit switches are active LOW.
* Simulated ADC voltage assumes a calibrated 6:1 divider. GPIO34 reads battery voltage; this is not a specified module ratio.
GPIO25 → RPWM · GPIO26 → LPWM
GPIO27 → R_EN · GPIO14 → L_EN
M+ → Motor + · M− → Motor −
B+ → fused battery + · B− → common ground
VCC → 5V · GND → common ground
CONTROL SIDE (physical order)
GND4 · PWM4 · GND3 · PWM3
GND2 · PWM2 · GND1 · PWM1
LOAD SIDE (physical order)
OUT4− · OUT4+ · OUT3− · OUT3+
OUT2− · OUT2+ · OUT1− · OUT1+
DC− · DC+
DC+ → fused battery + · DC− → ground
OUT1+ / OUT1− → LED via INA219
OUT2+ / OUT2− → warning buzzer
OUT3+ / OUT3− → SPARE
OUT4+ / OUT4− → SPARE
GPIO19 → PWM1 · GPIO18 → PWM2
GND1 and GND2 → common ground
All specified GPIO assignments are preserved. GPIO34 is an input-only ADC1 pin, suitable for voltage sensing.
This is a design visualization, not a validated construction schematic. Board dimensions and terminal positions are simplified. Match the silkscreen on your actual 30-pin board; NodeMCU-32S variants can differ.
I2C sensors run from ESP32 3V3. Ensure SDA/SCL pull-ups go to 3.3V, never 5V. DS3231 backup-cell charging circuits vary: verify the battery type and module design.
BTS7960 and MOSFET inputs must recognize 3.3V logic. Verify the actual module or add an appropriate buffer. MOSFET channels are shown as common-positive, low-side switched outputs; confirm your module topology.
Generic 5:1 modules may exceed the ESP32 ADC calibrated range at full LiFePO4 charge. Use a calibrated divider rated for the maximum charge voltage, with output within your configured ADC range and always below 3.3V. GPIO34 must never connect directly to battery positive.
INA219 is intentionally placed in the LED positive branch only. Size its shunt and PCB current rating for the LED; do not route geared-motor stall current through a typical breakout.
The fuse holder models the shared fused feed to the motor and MOSFET. Size fuse, wire gauge, driver, BMS and branch protection for actual motor stall current. The buck branch is shown as requested; add suitable battery-side protection in a physical build. Place protection near battery positive.
Choose a controller and BMS for 4S LiFePO4 and the panel voltage. Controller BAT− shares the common ground; PV− is routed only to controller PV−, allowing controller topology differences. Never connect a solar panel directly to the battery.
Do not power ESP32 from USB and external 5V simultaneously unless your board provides safe power isolation. 12V loads must tolerate the full battery charge voltage.
Demo values are simulated. Limit switches stop travel; STOP cancels movement and buzzer. A real emergency stop needs suitable hardware isolation.
Espressif ESP32 datasheet ↗